Dune Buggy Frames For Motorcycle Engines

flash the firmware




Flashing rmt files
. . rmt files are signed. img files. You can use the Web interface

be flashed.

http://10.0.0.138/index.cgi?active_page=747 (Advanced-> PRGAV4202N Firmware Update-> From a computer on the network aktualisieren. / Update Now) Here you can spend. Rmt file select and upload / flash.




Flashing . Img files

. Img files can only be flashed via the CLI

. This is needed only once a TFTP daemon (eg Tftpd32 ).


The . Img file sets to the Tftpd32 folder. to start flashing you have to do the following:

flash load-u tftp: / / 10.0.0.2/image_name.img-s 1


system reboot



10.0.0.2 is listening in my case the IP on which the TFTP daemon
image_name.img
here is given to the filename of the desired image is a

-s causes a
that the image is flashed in the sector 1 - Firmware images are always in the range 1 - Recovery images always in sector 2 (
layout
shows the distribution of flash memory on) system reboot
the router reboots


Warning:
a "product change" from
Centro Grande
(Swisscom) on PRGAV4202N (Telekom Austria) - and vice versa - is possible only through the flashing of an img file..

If something wrong go ...


If the image in 3-sector 1 can not even boot, then the recovery image (sector 2) is booted. These concerns can flash a stripped version with the OpenRG one at least. img files. (. Rmt files can not know to flash.) The router IP is 192.168.1.1.


Furthermore, the boot loader to second Recovery mode is provided. This one, by switching off the router (power button), press the reset button is activated (hold) and then turn on your router. The power LED should turn red. If one now uses static IP to 192.168.1.2, can get a
to http://192.168.1.1 . Img file flash upload.